 |
|
Date |
: Apr 5th, 2002 |
| Category |
: Cases |
| Manufacturer |
: Cooler Master |
| Author |
: Tom Smith |
|
First I took the whole case apart. I slid out the motherboard tray and attached the stand offs to where they needed to be.
Next I installed the Enermax 365 Watt power supply. So here's where we run into some issues. The power supply is a royal pain to install this way. So I installed it from inside the case and then attached it to the adapter plate. Notice what it did to the upper motherboard tray guide. Granted this did make the tray slide in a little tighter, but not so much that you could notice.
Installing the 5 1/4" drives was a snap. I personally would like to have seen the case have rails for quick removal, but the current system works. The same applies to the 3 1/2" drives. Again drive rails would be a great asset.
Now while installing the hard drives you will notice that the front panel connectors and LEDs are there. Be aware of how close you are to them. I think that I may have busted the power LED when I installed the second hard drive. Not to worry though I have a replacement.
Click To Enlarge
|
